Status: Übersicht

Creating 5 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "cfe"
0x00040000-0x003f0000 : "linux"
0x000b3c9c-0x00240000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x003f0000-0x00400000 : "nvram"
0x00240000-0x003f0000 : "OpenWrt"
diag boardtype: 00000467
Probing device eth0: found!
eth1: Broadcom BCM4320 802.11 Wireless Controller 3.90.37.0
CRONDOG: Timer margin: 600 sec
ip_conntrack version 2.1 (5953 buckets, 5953 max) - 332 bytes per conntrack
Flushing ip conntrack...

Chain PREROUTING (policy ACCEPT 70188 packets, 18M bytes)
 pkts bytes target     prot opt in     out     source               destination         

Chain POSTROUTING (policy ACCEPT 644 packets, 40950 bytes)
 pkts bytes target     prot opt in     out     source               destination         
    0     0 MASQUERADE  all  --  *      vlan1   0.0.0.0/0            0.0.0.0/0           
    0     0 MASQUERADE  all  --  *      eth1    192.168.2.0/24      !192.168.2.0/24      

Chain OUTPUT (policy ACCEPT 644 packets, 40950 bytes)
 pkts bytes target     prot opt in     out     source               destination         

lan_ifnames=vlan0 eth2
lan_ifname=br0
wl0_ifname=eth1
wifi_ifname=
wan_ifname=vlan1

bridge name	bridge id		STP enabled	interfaces
br0		8000.0016b6ede7ba	no		vlan0

1: lo:  mtu 16436 qdisc noqueue 
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
2: eth0:  mtu 1500 qdisc pfifo_fast qlen 1000
    link/ether 00:16:b6:ed:e7:ba brd ff:ff:ff:ff:ff:ff
3: tunl0@NONE:  mtu 1480 qdisc noop 
    link/ipip 0.0.0.0 brd 0.0.0.0
4: eth1:  mtu 1500 qdisc prio qlen 1000
    link/ether 00:16:b6:ed:e7:bc brd ff:ff:ff:ff:ff:ff
    inet 193.238.158.15/24 brd 193.238.158.255 scope global eth1
5: br0:  mtu 1500 qdisc noqueue 
    link/ether 00:16:b6:ed:e7:ba brd ff:ff:ff:ff:ff:ff
    inet 192.168.2.2/24 brd 192.168.2.255 scope global br0
6: vlan0:  mtu 1500 qdisc noqueue 
    link/ether 00:16:b6:ed:e7:ba brd ff:ff:ff:ff:ff:ff
7: vlan1:  mtu 1500 qdisc noop 
    link/ether 00:16:b6:ed:e7:ba brd ff:ff:ff:ff:ff:ff

ff_autoupdate=yes
ff_bssid=4E:FE:52:36:2E:65
ff_dnsmasq=1
ff_except_dnsmasq_mesh=1
ff_ipkg=src freifunk http://ipkg.funkfeuer.at/ipkg/freifunk/packages;src funkfeuer http://ipkg.funkfeuer.at/ipkg/1.7
ff_lan_proto=1
ff_mini_fo=1
ff_mtu=750
ff_nonetmsg=0
ff_noprobe=1
ff_range=193.238.156.0/22;78.41.112.0/21
ff_reset=ae912efdaa1d4417639da88725762107
ff_tz=MET-1MEST-2,M3.3.0,M10.5.0
lan_ifname=br0
lan_ifnames=vlan0 eth2
lan_ipaddr=192.168.2.2
lan_netmask=255.255.255.0
lan_proto=static
vlan0hwname=et0
vlan0ports=3 2 1 0 5*
vlan1hwname=et0
vlan1ports=4 5
wan_device=vlan1
wan_dns=8.8.8.8
wan_hostname=sche11
wan_ifname=vlan1
wan_proto=disabled
wifi_ipaddr=193.238.158.15
wifi_netmask=255.255.255.0
wifi_proto=static
wl0_antdiv=0
wl0_bcn=200
wl0_channel=1
wl0_closed=0
wl0_country_code=Nicht konfiguriert
wl0_distance=300
wl0_dtim=5
wl0_frag=750
wl0_frameburst=off
wl0_gmode=1
wl0_gmode_protection=off
wl0_ifname=eth1
wl0_infra=0
wl0_mode=sta
wl0_mrate=5500000
wl0_phytype=g
wl0_radio=1
wl0_rate=5500000
wl0_rateset=default
wl0_rts=750
wl0_ssid=v1.freiesnetz.www.funkfeuer.at
wl0_txant=0

1	193.238.158.15
1	194.169.175.35
2	18.224.51.168
3	127.0.0.1